›
Please review the site Rules, Terms of Service, and Privacy Policy at your convenience. Rules, TOS, Privacy
Get familiar with the reaction system: Introducing the Reaction System

Taured TM

isaeagle4031isaeagle4031
in DIY
After building the MTM version, I was asked for a TM version. Nothing special about the cabinets here. Just BB and MDF. I was planning to miter the corners. However the tilt whee on the table saw decided now was the time to self destruct. Fixable, but not today. Cabinets are .75 cubes and the 2" port will give these an f3 of about 38Hz and f10 about 30. Plan is to have them, sans finish, at Meniscus .
BrannigansLawrjj45JasonPS7910hifisidekonfyoused

Comments

  • isaeagle4031isaeagle4031

    JasonP6thplanethifiside
  • isaeagle4031isaeagle4031
    Couple more pics. Deciding on finish now. 
  • JasonPJasonP
    Looking great! I like the bracing structure a lot.
    = Howard Stark: "This is the key to the future. I'm limited by the technology of my time, but one day you'll figure this out."
  • Shawn_KShawn_K
    Is that the Rival 7" Kevlar Woofer?
  • isaeagle4031isaeagle4031
    Shawn_K said:
    Is that the Rival 7" Kevlar Woofer?
    yep, Same i used in the mtm

  • Shawn_KShawn_K
    I have a pair of the 7" Rival Kevlar woofers and haven't had time to do any measurements on them. Does the FR have a lot of cone breakup? What kind of low pass crossover filter are you using?
  • isaeagle4031isaeagle4031
    Very little breakup. And what is there is more about reflection off of the surround. For low pass, i have used 3rd order electrical each time.
    rjj45
Sign In or Register to comment.