AMT monitor coming up

jr@mac

Going to get some cabs glued up and baffles cut this week - do a quick monitor design using Gradient AMT and MCM 3669. Might be stretching it a bit to get them to meet up, but they should both do 2500 reasonably well. I might be able to push the woofer to 2750 if I have to. I'll see how they behave in a cabinet before jumping to conclusions.



I have used this woofer and its white cone counterpart many, many times. Still the best driver out there under 6" and $25. Competes with quite a few drivers well outside of that price range, as well, to be honest. 

Anyways, should be a fun little project and if anyone grabbed any of these AMT when MCM was clearancing them out...

rjj45

Interesting GA AMT - was that from the MCM clearance?
I Googled it and found a "challenging" FR, but very low distortion.
Nice!

jr@mac

Yep, MCM clearance. Advertised response is wonky, but probably workable. Maybe I'll DSP it if nothing else.

Wolf

I wondered about those AMTs too... Just never bit on them.

D1PP1N

Nice looking combo. Let me know if there are any measured differences. I like the way those look mkre!

jr@mac

Change in direction, going with the Sony OEM woofers here: http://diy.midwestaudio.club/discussion/704/midwoofers-from-sony-mb-150h#latest

Save the MCM (I have a metric fuckton of them for some reason) for a tower build at some point. 

ScottS

What is the conversion factor for metric vs. US fucktons?

jr@mac

Good question!