It looks like you're new here. If you want to get involved, click one of these buttons!
First off, I realize the timing for this request isn't great. With that in mind, here we go. I have a confession to make. I do not have measurement gear. Never have. Any time I've gone "off the reservation" I've used carefully chosen drivers and measurements and the "Speaker Designing with Software" pointers from Wolf, Paul Carmody, et al from the PETT board as my starting point. Sometimes it works, sometimes you tear down and start over. The keepers have been a blast.
I was content with this approach until a few months ago, when I not only got laid off, I also lost the laptop with all my history of work on it. I am not a Windows guy at home. So now I have just a couple of projects left to complete before I hang up the soldering iron, but I can't do that without some assistance. Here is what I have left to finish:
At last year's DIYIA someone had a build with the Dynavox LW6004HR-N honeybomb woofers that I really liked. So when they were deeply discounted last fall, I buckled. I currently have boxes built that will be vented and should net about 21-22L.
The second project I'd like to finish uses the HiVi F6. The vented boxes should net at about 18L.
I can use any of 3 tweeters to finish this pair of 2-ways. I have avoided cutting the holes since they are not the same diameter. The tweeters:
So, there is a little work left to do on the cabinets, but not much to get to mounting drivers. If there is anyone out there, preferably in IOWA (I'm in the Des Moines area) who could help out a poor speaker cobbler with the measuring voodoo that makes these sing, please inquire or reply on or offline so we can work out possible next steps, recommendations etc., etc. If I could even get one pair playing for the Ankeny show I would be very happy. If not, maybe an Ankeny how-to demo if it's not too time consuming??? [thinking out loud there...]
Thanks for looking. You guys are great.