›
Please review the site Rules, Terms of Service, and Privacy Policy at your convenience. Rules, TOS, Privacy
Get familiar with the reaction system: Introducing the Reaction System

New 3 way project - The Clinchers!

13»

Comments

  • 6thplanet6thplanet
    Could you drill a hole for the mic to poke through?
  • PWRRYDPWRRYD
    6thplanet said:
    Could you drill a hole for the mic to poke through?
    I was thinking about that.  The OmniMic would only need a ~1/4" hole.  Easy enough to fill in and would never be seen when covered in veneer.
  • 6thplanet6thplanet
    Exactly, centered between the port and woofer, maybe? If it's a test enclosure I'd try multiple locations and see what kind of changes are seen to see if it matters where the best reading comes from.
  • PWRRYDPWRRYD
    Well I gave it two more attempts with the mic in very different orientations.  Almost exactly the same outcome in all three mic positions.  As a sanity check I ran a near field FR on the woofer (1/4" from dust cap).  The woofer, port, and enclosure are functioning exactly as predicted by the measured T/S parameters with Unibox.  Maybe AJ was giving us a zinger  :o
    6thplanet
  • PWRRYDPWRRYD
    I will post the measurements later but this is the lowest distortion woofer I have ever measured.
Sign In or Register to comment.